Call and Reset Button

(1 vote, average 5.00 out of 5)
Rate this item
(1 Vote)
Written by  Published in: IP Nurse Call System

Call and Reset button allows the activation of certain, and deactivation of all, types of calls within a room directly at a bed and may replace the room terminal in special cases. It is possible to control the LED CL lamp directly from the module or activate emergency calling from the WC. In contrast to the room terminal, this module does not allow the registration of ancillary personnel. It is located near the patient's bed as a part of the bed connection. It can be located at each connection, or only for the first in a series from entry door to a ward it always depends on the customer requirements.

Read 725 times
2

CEO & Founder

Leave a comment

Make sure you enter all the required information, indicated by an asterisk (*). HTML code is not allowed.